Under Tile/Stone on 6″ concrete with a ceiling assembly below, TMS Plus achieved an STC rating of 66, an IIC of 66 and ∆IIC 22.
Under Tile/Stone on plywood/gypcrete with a ceiling assembly below, TMS Plus achieved an STC rating of 59, an IIC of 52.
Under LVT/LVP on 6″ concrete with a ceiling assembly below, TMS Plus achieved an STC rating of 66, an IIC or 71 and ∆II 25.
ASTM C627 Robinson testing proves its suitability for lt. commercial & residential use. The ANSI A118.12.5.4 standards for High Performance System Crack Resistance add value to the life of the floor along with the membranes passing ANSI 118.10.5.4 Hydrostatic Pressure testing by the TCNA.
Certified exposure testing completed utilizing DemoFlex reported “non-detectable” Silica exposure levels which is the lowest reportable level of exposure. So far below the Permissible Exposure Limit (PEL) 25 µg/m3 standard set by OSHA-1926.1153 that during tile floor demo, users can avoid the extra engineering controls that OSHA typically requires.
See Product Data Spec Sheet for full details: from a standing position, spray the DemoFlex Adhesive onto the floor substrate/concrete, wait 20-40 minutes for the adhesive to activate, then thoroughly press the TMS/TMS Plus into the DemoFlex Adhesive and it is immediately ready to set the Mortar, Tile and Grout directly on top of our membrane following industry standards.
Treat the seams & perimeter of TMS or TMS Plus with our provided DemoFlex Tape or your choice of high quality silicone caulk or liquid waterproofing.
